| • |
Automatic, Door stand open, One way traffic, Two way traffic, Night lock, Manual open by hand and closing by spring, Push & Go (automatic opening by pushing), Synchronization of two operators, Cyclic opening and closing |
| • |
Heavy Duty or Low energy application |
| • |
Spring strength selection |
| • |
Activation arms in stainless steel, pushing or slide type. |
| • |
Power Requirements: 230 VAC / 50hz |
| • |
IP22 protection |
| • |
Opening Time Adjustment: 0-20 s |
| • |
Inputs for motion detectors, presence sensors and photocells |
| • |
DC Output: for Auxiliary sensors and electric lock |
| • |
Adjustable door opening angle. |
| • |
Power failure - doors close by spring |
| • |
Adjustments (via operator or digital selector) |
| • |
Regulation of opening and closing speeds |
| • |
Regulation of acceleration and deceleration's |
| • |
Safety sensor inhibiting distance in opening mode |
| • |
Pushing thrust limitation |
| • |
Pause time(0-20s) |
| • |
Wind stop force intensity |
| • |
Push and go activation distance |
| • |
Intensity of final thrust on closing phase to ensure electric lock is latched |
| • |
Release time of 0.5 seconds for lock before opening of door |
| • |
You can have a right or left opening door, push or pull opening, speed and power opening mode: for every mode of the assembly the same operator can be used. |
| • |
Activation of the functions can be selected via the on board 3 way switch on the lateral side of the operator, key switch or via a digital selector. |
| • |
Programming the functions and parameters can be done by the on board dip switch or via the digital function selector |
| • |
The regulation of the opening angle (maximum 95°) must be adjusted at the initial installation of the operator |
| • |
In a power fail situation it can be opened by hand and closed by spring |
|
